Sometimes it's more convenient to drive up ramps then jack the car up and set it on stands.
Ramps are 67 " long and 14" wide with a 10" lift height and a low 10.8 degree incline. One set supports 3000 lbs. Includes handy straps for carrying and storage. The 2 pcs. design allows removal of the bottom portion of the ramp for easier side access ,once car is set on ramp. At only 15 lbs each working with these ramps is a breeze. These ramps never scoot, slip or slide while rolling onto the ramps.All that said means these ramps are easy to drive up on and very safe. Our Schwaben ramps will never scratch or blemish your floors.
See chart below to determine if these 67" ramps are right for your application.
Please refer to chart below to see if these 67" Schwaben ramps are right for you vehicle.
1. Take a yardstick, and wedge it under the front edge of front tire.
2. Raise it up until it hits the underside of your car( the spoiler)
3. Measure from the tip of the yardstick to the ground, vertically.
If your measurement is 7.25" or greater, you can clear these ramps with no problem. Note: If you need something even lower see our ES2748970 extensions for use with these ramps.
These extensions will lower your approach angle to 6.6 degrees. Once you get the car into place, you can remove the extensions for more working room under the vehicle. One set holds up to 3000 lbs.
For increased safety, use wheel chocks with all Schwaben Ramp products.
This Part Fits the Following Vehicles