Please Note: Only available for purchase and shipment within the United States
Fully adjustable upper control arms are available in both Camber Correcting and Track Spec varieties.
Camber Correcting: Perfect for those who have lowered their car from OEM ride height and are looking to correct camber to factory specs and reduce excessive inside tire wear.
- CNC Machined Billet 6061 Construction, Black Anodized Finish
- 034Motorsport Density Inner Bushings
- Aurora Spherical Bearings Featuring Teflon Race Lining
- Built in Safety Washer to eliminate any chance of the spherical ever separating
- Arm sets ship set to factory OEM length
- Camber Correcting: These offer over 5/8" of outward adjustability from stock length, adjustable in 1/36" increments, each 1/36 adjustment is approximately .1 degrees for highly accurate adjustments.
- No tightening creep like you get with a turn buckle.
- Adjustments can be easily made by threading out an M6 head allen bolt, the pinch pin stays installed in the upright. A jam nut keeps everything tight once adjusted.
- Dust boots are now included with all adjustable upper control arms. We ship the boots uninstalled; once you have the alignment set, install the dust boots before final installation.
Note - Do not run the heims with less than 8 threads in the control arm itself, less threads can cause failure of the part and 034Motorsport will not be responsible for installation errors. If your alignment requires that you must have less than 8 threads engaged then contact us, but do not run the car with less than 8 threads engaged! Tighten M10 pan head allen bolt to 45 ft/lbs with blue loctite.
This Part Fits the Following Vehicles
|Audi||B8 A4||Quattro||V6 3.2L|
|Audi||B8 A5||Quattro||V6 3.2L|
|Audi||B8 S5||Quattro||3.0T Cabriolet|
|Audi||B8 S5||Quattro||3.0T Coupe|
|Audi||B8 S5||Quattro||V8 4.2L|
|Audi||C7 A6||FWD||V6 3.0T|
|Audi||C7 A6||Quattro||3.0 TDI|
|Audi||C7 A6||Quattro||V6 3.0T|