Looking to make your E/F Series BMW faster in the 1/4 mile or 1/2 mile racing? Want to run 17' or 15' wheels s in the front? Want to drop OVER 62lbs of unsprung weight off the front of the car at the same time? Do not want to break the bank while doing so? Look no further than the VTT Ultimate Front Drag kit for the E/F Series BMWs. This kit will allow you to run the wheel/tire combo you need to drop your ET’s all while putting the car on a significant diet over the stock front brake set up.

The kit is a true plug-and-play kit using Genuine Wilwood parts, coupled with DOT-approved brake lines, CNC 7075 rotor hats/brackets, and a CEL eliminator harness for the brake sensor.

This kit comes in 2 different variations, with two different caliper Options for each. We HIGHLY suggest 6-Piston Calipers for street driving, and 1/2 mile racing. These calipers will drop weight, AND be a braking upgrade over stock calipers.

PLEASE NOTE: E SERIES WILL ALLOW 15' WHEELS ON THE FRONT WITH NO MODIFICATIONS. CAREFUL SELECTION OF OFFSET WILL BE NEEDED TO CLEAR THE INBOARD STRUT, TOO MUCH NEGATIVE OFFSET WILL NOT CLEAR WITHOUT SPACERS.

 

This kit comes in 2 different variations, with two different caliper sizes for each

HD Version: Normal street driving, and racing duties

• Wilwood Spec 37 HD rotors
• Genuine Wilwood Dyna-Pro Calipers
• Genuine Wilwood BP-20 Brake Pads
• DOT Approved Brake lines
• VTT CNC Rotor Hats
• VTT CNC Brackets
• Brake Sensor CEL ELiminator harness

Race Version: Recommended Race Duties only, not for street use

• Genuine Wilwood Ultra-Lite Scalloped rotors
• Genuine Wilwood Dyna-Lite Calipers
• Genuine Wilwood BP-20 Brake Pads
• DOT Approved Brake lines
• VTT CNC Rotor Hats
• VTT CNC Brackets
• Brake Sensor CEL ELiminator harness

Weight saving information

VTT Dragkit vs OEM Per Side:

• OEM Steel kit 46lbs per side – Total 84 lbs
• VTT HD Kit Spec 37 Rotors- 16.1 Lbs per side – 30.3 Lbs total – 53.7 Lbs savings over Stock steel kit
• VTT Scalloped kit – 10.7 Lbs per side – 21.4 Lbs total – 62.6 Lbs savings over Stock steel kit!!!

More weight information:

• HD Rotor Spec 37- 9 Lbs
• Scalloped Rotor – 5.1 Lbs
• Dyna Lite Caliper 3.2 Lbs
• DynaPro Caliper 3.6Lbs
• DynoPro 6 Piston Caliper 5.1 Lbs
• Rotor Hat 1Lb
• Pads (one side) 1.0 Lbs

Disclaimer: The HD kits are designed for street use, and drag racing. Never use for heavy braking racing environments such as Auto-X or Road Racing. Scalloped kits should never be used for street driving, and are ONE-PASS COOLDOWN DRAG RACING ONLY, EVEN IN THIS ENVIRONMENT, THEY MAY CRACK IF USED TOO AGGRESSIVELY. Always drive within your limits!