The needle nose design on these heavy-duty battery clamps ensure fitment in tight spaces for both 12-volt gas and diesel engines.
This product was last offered at the strikethrough price on
05-02-2026
The needle nose design on these heavy-duty battery clamps ensure fitment in tight spaces for both 12-volt gas and diesel engines.
This product was last offered at the strikethrough price on
05-02-2026
This heat wrap protects your engine harness from damaging any of your wires
MSRP stands for Manufacturer's Suggested Retail Price. This is the suggested retail price provided by the manufacturer, supplier or seller.
This product was last offered at the strikethrough price on
07-21-2026
Located between the retaining ring and fuel tank
We Price Match - Give Us A Call or Chat!
Pressure switch located on the oil cooler bracket. .55-.85 BAR
2X Entries For Our 25th Anniversary Sweepstakes!
We Price Match - Give Us A Call or Chat!
This product was last offered at the strikethrough price on
05-07-2026
Secures the secondary air injection pump to the bracket
We Price Match - Give Us A Call or Chat!
Copper crimpable terminal ends for custom battery and kill switch installations
Pressure switch located on the oil cooler bracket. .55-.85 BAR
Extra length is needed sometimes
Monitors coolant temperature for fan control & gauge readings
2X Entries For Our 25th Anniversary Sweepstakes!
We Price Match - Give Us A Call or Chat!
Replacement tool intended to make fuse pulling trouble free
Replacement 4 pin relay
Relay for auxiliary water pump
This product was last offered at the strikethrough price on
05-07-2026
Plugs directly into your 12 volt receptacle to prevent lost presets and settings while the battery is disconnected.
Seals the throttle body to the intake manifold
This product was last offered at the strikethrough price on
05-07-2026
Secures the coolant temperature sensor in place
2X Entries For Our 25th Anniversary Sweepstakes!
We Price Match - Give Us A Call or Chat!
Bolt designed to shear once it reaches correct torque spec. M5x14
Used to hold engine control unit in the securing bracket/cover
Install new hardware with your new parts. M8x30