Securely mount an Odyssey battery in your Audi
Audi B7 A4 Quattro V6 3.2L Engine Electrical Parts
- Alternator
- Battery
- ECU
- Fuse Panel
- Harness
- Ignition
- N205 Valve
- N75 Valve
- Pump
- Relays
- Sensors
- Starter
- Throttle Body
- Wire Covering
Switch, remote pull, and battery are not included with this or any of the kits.
This product was last offered at the strikethrough price on
07-15-2026
Manifold absolute pressure sensor, lets your ECU know how much air pressure is in your intake manifold
This product was last offered at the strikethrough price on
05-07-2026
Informs the instrument cluster of the tank's fuel level
This product was last offered at the strikethrough price on
05-07-2026
Price includes $150 refundable core charge
Price includes a $75 core charge
A two-bank onboard battery charger rated at 20-amps (10-amps per bank) for 12-volt batteries, including marine, boat, starter, and deep-cycle batteries.
MSRP stands for Manufacturer's Suggested Retail Price. This is the suggested retail price provided by the manufacturer, supplier or seller.
This product was last offered at the strikethrough price on
08-05-2026
Purchase the wires you need for your electrical bulkhead fitting here. Featuring Black FEP wire pre-cut to 24" 12 Gauge wire with the appropriate terminal pre-crimped and ready to install!
Purchase the wires you need for your electrical bulkhead fitting here. Featuring Orange FEP wire pre-cut to 24" 12 Gauge wire with the appropriate terminal pre-crimped and ready to install!
Purchase the wires you need for your electrical bulkhead fitting here. Featuring Black FEP wire pre-cut to 24" 18 Gauge wire with the appropriate terminal pre-crimped and ready to install!
Purchase the wires you need for your electrical bulkhead fitting here. Featuring White FEP wire pre-cut to 24" 12 Gauge wire with the appropriate terminal pre-crimped and ready to install!
Purchase the wires you need for your electrical bulkhead fitting here. Featuring Blue FEP wire pre-cut to 24" 12 Gauge wire with the appropriate terminal pre-crimped and ready to install!
Purchase the wires you need for your electrical bulkhead fitting here. Featuring FEP wire pre-cut to 24" 12 Gauge wire with the appropriate terminal pre-crimped and ready to install!
Located between the retaining ring and fuel tank
2X Entries For Our 25th Anniversary Sweepstakes!
Seal for most clip-in cooling sensors/senders. M19.6x3.6mm
2X Entries For Our 25th Anniversary Sweepstakes!