Low pressure screw in oil pressure switch. M10x1
AAN Engine Code Only
Low pressure screw in oil pressure switch. M10x1
AAN Engine Code Only
Blue sensor used by the ECU to control engine fueling
5X Entries Into Our F80 M3 Sweepstakes
We Price Match - Give Us A Call or Chat!
Secures the wiring harness cover
Low pressure screw in oil pressure switch. M10x1
5X Entries Into Our F80 M3 Sweepstakes
We Price Match - Give Us A Call or Chat!
AAN Engine Code Only
M14x1.5 Thread
2X Entries Into Our F80 M3 Sweepstakes
We Price Match - Give Us A Call or Chat!
Purchase the wires you need for your electrical bulkhead fitting here. Featuring FEP wire pre-cut to 24" 18 Gauge wire with the appropriate terminal pre-crimped and ready to install!
For 6.5mm holes with 0.6-1.8mm sheet metal thickness
MSRP stands for Manufacturer's Suggested Retail Price. This is the suggested retail price provided by the manufacturer, supplier or seller.
This product was last offered at the strikethrough price on
09-04-2026
With award-winning Swedish technology, the dual input D250SE allows you to enjoy your vehicle more
This product was last offered at the strikethrough price on
05-02-2026
Cure misfires and clear the check engine light
Beru unit that is mounted on right firewall, there is two per car
Ignition Timing Sensor
Located on the rear of the alternator
Switch, remote pull, and battery are not included with this or any of the kits.
A two-bank onboard battery charger rated at 20-amps (10-amps per bank) for 12-volt batteries, including marine, boat, starter, and deep-cycle batteries.
MSRP stands for Manufacturer's Suggested Retail Price. This is the suggested retail price provided by the manufacturer, supplier or seller.
This product was last offered at the strikethrough price on
09-04-2026
Purchase the wires you need for your electrical bulkhead fitting here. Featuring Black FEP wire pre-cut to 24" 12 Gauge wire with the appropriate terminal pre-crimped and ready to install!
Purchase the wires you need for your electrical bulkhead fitting here. Featuring Orange FEP wire pre-cut to 24" 12 Gauge wire with the appropriate terminal pre-crimped and ready to install!
Purchase the wires you need for your electrical bulkhead fitting here. Featuring Black FEP wire pre-cut to 24" 18 Gauge wire with the appropriate terminal pre-crimped and ready to install!