Attaches to the throttle body side of the accelerator cable
Attaches to the throttle body side of the accelerator cable
Water Methanol Tubing
Grab everything you need to start your WMI build!
E-6000 is semi flexible, 100% methanol resistant, and the only sealant recommended for use with Snow Performance water methanol injection systems.
Connected to the Y hose from the idle control valve
MSRP stands for Manufacturer's Suggested Retail Price. This is the suggested retail price provided by the manufacturer, supplier or seller.
This product was last offered at the strikethrough price on
10-05-2026
Inexpensive, compact, and easy to mount.
Water methanol nozzle holders securely connect either nylon line or braided line directly to your water methanol nozzle
Runs from Idle stabilizer to the intake manifold
Includes connector housing with terminals and seals. Commonly used for the idle air control valve (IACV).
10X Entries Into Our F80 M3 Sweepstakes
This product was last offered at the strikethrough price on
06-13-2026
This kit upgrades your WMI plastic lines to stainless steel BMS Elite braided lines.
Snow Performance Hyper-Sonic water-methanol injection nozzle
Snow Performance Hyper-Sonic water-methanol injection nozzle
Repair your intake manifold
Added protection for your WMI setup
Allows your JB4 to control a WMI pump and solenoid for dynamic progressive flow mapping!
For use in setups where charge pipe injection is being utilized.
1/4" tee fitting for water/methanol lines