8.5:1 Compression Ratio, Standard 84mm Bore
8.5:1 Compression Ratio, Standard 84mm Bore
Stainless Steel exhaust tip featuring a 2.5" Inlet & a 3.5" Double Wall, Angle Cut Outlet
10X Entries Into Our F80 M3 Sweepstakes
Not vehicle specific. You MUST measure prior to purchasing!
This product was last offered at the strikethrough price on
05-02-2026
Proportionally injects more or less water/methanol according to boost pressure
Stainless Steel exhaust tip featuring a 2.5" Inlet & a 4.0" Double Wall, Angle Cut Outlet
10X Entries Into Our F80 M3 Sweepstakes
Not vehicle specific. You MUST measure prior to purchasing!
This product was last offered at the strikethrough price on
06-13-2026
Street Camshaft Setup
Integrated pump mount for a super clean install. Available in two colors.
Pump does NOT have a check valve
This is Universal and Not a direct replacement for the Genuine Pump!
Serious engine oil cooling for the most demanding engines
For custom applications only. Not a direct bolt on.
Serious engine oil cooling for the most demanding engines
For custom applications only. Not a direct bolt on.
A fine tuned note and aggressive styling - requires Supersprint 781902 for installation
100% handcrafted in Italy. Stainless steel construction. Legendary sound
For Eventuri Intake Systems and many other performance air filters
Universal exhaust tips with a swivel adjustability to fine tune your exhaust. 2.5" Inlet & a 3.5" Double Wall, Angle Cut Outlet
10X Entries Into Our F80 M3 Sweepstakes
Can be used on any 2.5" exhaust piping. Measure before ordering.
This product was last offered at the strikethrough price on
06-13-2026
Includes cleaner and re-oil additive
Stainless Steel exhaust tip featuring a 2.5" Inlet & a 4.0" Double Wall, Angle Cut Outlet
10X Entries Into Our F80 M3 Sweepstakes
Not vehicle specific. You MUST measure prior to purchasing!
This product was last offered at the strikethrough price on
06-13-2026
Genuine Bosch Motorsports EV14 fuel injectors featuring USCAR (EV6) connector matched and packaged in pack of 6 units - Minimum flow of 1600cc @ 3bar (43.5 PSI industry standard)
NOT A DIRECT REPLACEMENT FOR FACTORY INJECTORS - For use with aftermarket port injection kits only