Mount for the idle regulator valve
Mount for the idle regulator valve
Attaches to the throttle body side of the accelerator cable
Includes connector housing with terminals and seals. Commonly used for the idle air control valve (IACV).
10X Entries Into Our F80 M3 Sweepstakes
This product was last offered at the strikethrough price on
06-13-2026
E-6000 is semi flexible, 100% methanol resistant, and the only sealant recommended for use with Snow Performance water methanol injection systems.
This kit upgrades your WMI plastic lines to stainless steel BMS Elite braided lines.
Added protection for your WMI setup
Snow Performance Hyper-Sonic water-methanol injection nozzle
Larger gasket that seals 2 of the intake ports, 1 required
For vehicles with production date from 12/1986 | Also use- (Qty.) (4) 11 61 1 726 010 gasket.
Includes cleaner and dirt retention additive
Water methanol nozzle holders securely connect either nylon line or braided line directly to your water methanol nozzle
Inexpensive, compact, and easy to mount.
Rubber boot between air flow meter and throttle body
For vehicles with production between from 11/1988
Rubber mount for air flow sensor assembly
MSRP stands for Manufacturer's Suggested Retail Price. This is the suggested retail price provided by the manufacturer, supplier or seller.
This product was last offered at the strikethrough price on
10-31-2026
Snow Performance Hyper-Sonic water-methanol injection nozzle
Allows your JB4 to control a WMI pump and solenoid for dynamic progressive flow mapping!
For use in setups where charge pipe injection is being utilized.
1/4" tee fitting for water/methanol lines