Attaches the Intake tube and MAF sensor
Attaches the Intake tube and MAF sensor
E-6000 is semi flexible, 100% methanol resistant, and the only sealant recommended for use with Snow Performance water methanol injection systems.
Control heat and dress up your engine bay
This kit upgrades your WMI plastic lines to stainless steel BMS Elite braided lines.
Snow Performance Hyper-Sonic water-methanol injection nozzle
Seals the intake intake boot
Does not include gasket
We Price Match - Give Us A Call or Chat!
This product was last offered at the strikethrough price on
09-03-2026
Added protection for your WMI setup
Throttle housing to intake manifold
2X Entries Into Our F80 M3 Sweepstakes
We Price Match - Give Us A Call or Chat!
This product was last offered at the strikethrough price on
03-27-2026
Allows your JB4 to control a WMI pump and solenoid for dynamic progressive flow mapping!
For use in setups where charge pipe injection is being utilized.
High flow WMI solenoid with inline 40 micron filter
Located on the intake manifold or intake box
MSRP stands for Manufacturer's Suggested Retail Price. This is the suggested retail price provided by the manufacturer, supplier or seller.
This product was last offered at the strikethrough price on
09-09-2026
Boot that connects to the MAF
We Price Match - Give Us A Call or Chat!
This product was last offered at the strikethrough price on
05-07-2026
4 required per engine
2X Entries Into Our F80 M3 Sweepstakes
We Price Match - Give Us A Call or Chat!
Used through out your BMW
D=10.5. Found in the throttle body housing