Snow Performance Hyper-Sonic water-methanol injection nozzle
Snow Performance Hyper-Sonic water-methanol injection nozzle
Having idle problems and low RPM hesitation? Located on the intake manifold.
2X Entries Into Our F80 M3 Sweepstakes
We Price Match - Give Us A Call or Chat!
Water methanol nozzle holders securely connect either nylon line or braided line directly to your water methanol nozzle
Seals the intake intake boot
Having idle problems and low RPM hesitation? Located next to the intake manifold.
2X Entries Into Our F80 M3 Sweepstakes
We Price Match - Give Us A Call or Chat!
This product was last offered at the strikethrough price on
10-22-2026
Inexpensive, compact, and easy to mount.
Boot that attaches to the mass air sensor
MSRP stands for Manufacturer's Suggested Retail Price. This is the suggested retail price provided by the manufacturer, supplier or seller.
This product was last offered at the strikethrough price on
10-24-2026
15 PSI
Added protection for your WMI setup
Snow Performance Hyper-Sonic water-methanol injection nozzle
Complete with housing
Allows your JB4 to control a WMI pump and solenoid for dynamic progressive flow mapping!
For use in setups where charge pipe injection is being utilized.
Attaches the Intake tube and MAF sensor
1/4" tee fitting for water/methanol lines
Contains both gaskets needed
10X Entries Into Our F80 M3 Sweepstakes
This product was last offered at the strikethrough price on
10-08-2026
D=10.5. Found in the throttle body housing