Use to remove and install the rear transverse differential mount bushing in the rear sub-frame on 3 series
Use to remove and install the rear transverse differential mount bushing in the rear sub-frame on 3 series
Used on ear-type clamps found on CV joints, hoses, and some fuel filters.
Hub puller adapter to use B8800120 with a slide hammer. 5/8" x 18T UNF thread.
10X Entries Into Our F80 M3 Sweepstakes
This product was last offered at the strikethrough price on
05-02-2026
Commonly used, quality-made socket for your BMW
10X Entries Into Our F80 M3 Sweepstakes
This product was last offered at the strikethrough price on
05-02-2026
Differential Drain Plug Tool - 14mm
36mm, 12 point, 1/2" drive.
10X Entries Into Our F80 M3 Sweepstakes
This product was last offered at the strikethrough price on
05-02-2026
This tool is a must to properly disconnect the driveshaft.
Easily align your clutch disc for installation with this Kingsborne tool
For Use With Fluid Transfer Pumps
10X Entries Into Our F80 M3 Sweepstakes
This product was last offered at the strikethrough price on
05-02-2026
Pilot Bearing Puller
For turning and holding flexplates and flywheels.
Used to replace 5th and reverse gear selector bushings
For vehicles with production date up to 03/2003
Easily align your clutch disc for installation with this Kingsborne tool
Installation tool for the front wheel bearing hub on BMWs that use a stub axle
Useful for removal and re-installation of the flywheel or crank pulley
Extend you catch area by adding this funnel