Snow Performance Hyper-Sonic water-methanol injection nozzle
Snow Performance Hyper-Sonic water-methanol injection nozzle
Seals the intake intake boot
Intake boot that connects to the hot-film air mass meter.
MSRP stands for Manufacturer's Suggested Retail Price. This is the suggested retail price provided by the manufacturer, supplier or seller.
This product was last offered at the strikethrough price on
09-21-2026
Added protection for your WMI setup
4 required per engine
2X Entries Into Our F80 M3 Sweepstakes
We Price Match - Give Us A Call or Chat!
Throttle housing to intake manifold
2X Entries Into Our F80 M3 Sweepstakes
We Price Match - Give Us A Call or Chat!
This product was last offered at the strikethrough price on
03-27-2026
Allows your JB4 to control a WMI pump and solenoid for dynamic progressive flow mapping!
For use in setups where charge pipe injection is being utilized.
Ensure a proper seal between the outside elements and you engines internals!
5X Entries Into Our F80 M3 Sweepstakes
We Price Match - Give Us A Call or Chat!
Includes sealing o-ring
This product was last offered at the strikethrough price on
06-15-2026
Cure common problems with CEL & hesitations with a new mass air flow sensor.
Used through out your BMW
1/4" tee fitting for water/methanol lines
Common source of emission related issues
This product was last offered at the strikethrough price on
05-07-2026
Runs from the top of the oil separator up to intake manifold.
Adjustable (1-15 PSI) to engage at the appropriate amount of boost pressure for your application.
15 PSI