Added protection for your WMI setup
Added protection for your WMI setup
Stainless Steel exhaust tip featuring a 80MM Inlet & a 4.0" Double Wall, Slant Cut Outlet, Single Clamp On Tip
10X Entries Into Our F80 M3 Sweepstakes
Please note this is a universal tip. You MUST measure your exhaust before ordering to verify fitment for your application.
This product was last offered at the strikethrough price on
05-02-2026
Allows your JB4 to control a WMI pump and solenoid for dynamic progressive flow mapping!
For use in setups where charge pipe injection is being utilized.
High flow WMI solenoid with inline 40 micron filter
Increase air flow and lower intake temperatures with this simple modification!
This product was last offered at the strikethrough price on
09-01-2026
Unlike simple inserts, these are complete re-engineered replacements designed to outperform and outlast the BMW factory units.
2X Entries Into Our F80 M3 Sweepstakes
1/4" tee fitting for water/methanol lines
Left - Mirror Slash Cut Exhaust Tip - 2.75 Inlet - 3.5 OD
10X Entries Into Our F80 M3 Sweepstakes
Not vehicle specific. You MUST measure prior to purchasing!
This product was last offered at the strikethrough price on
06-13-2026
Adjustable (1-15 PSI) to engage at the appropriate amount of boost pressure for your application.
15 PSI
Use these in replacement of any standard short body EV14 style injector.
Replacement WMI Water Injection Hose
100 Micron Water-Methanol Filter
1" X 3ft
Replace those Worn Out Rod Bearings!
+0.50mm
4AN T