This kit upgrades your WMI plastic lines to stainless steel BMS Elite braided lines.
This kit upgrades your WMI plastic lines to stainless steel BMS Elite braided lines.
Snow Performance Hyper-Sonic water-methanol injection nozzle
Snow Performance Hyper-Sonic water-methanol injection nozzle
Connects to the airbox
MSRP stands for Manufacturer's Suggested Retail Price. This is the suggested retail price provided by the manufacturer, supplier or seller.
This product was last offered at the strikethrough price on
09-22-2026
MSRP stands for Manufacturer's Suggested Retail Price. This is the suggested retail price provided by the manufacturer, supplier or seller.
This product was last offered at the strikethrough price on
09-22-2026
Used to secure the intake boot
MSRP stands for Manufacturer's Suggested Retail Price. This is the suggested retail price provided by the manufacturer, supplier or seller.
This product was last offered at the strikethrough price on
09-22-2026
Added protection for your WMI setup
Located under the airbox
This product was last offered at the strikethrough price on
05-02-2026
Charge pipe & intake manifold sensor
For vehicles with a production date up to 06/2011
This product was last offered at the strikethrough price on
05-07-2026
Allows your JB4 to control a WMI pump and solenoid for dynamic progressive flow mapping!
For use in setups where charge pipe injection is being utilized.
Reduce intake manifold heat transfer with this spacer from Evolution of Speed!
Direct replacement charge pipe seal made from Viton to withstand all fuels and oils
Part of the charge pipe running from the throttle body to the lower charge pipe that connects to the intercooler
Replace your sensor and avoid poor fuel mileage and hampered performance
Add an Install Kit to Your Motiv ReFlex Control Unit!
1/4" tee fitting for water/methanol lines