Stop annoying boost leaks. Connects intercooler to upper charge pipe.
Stop annoying boost leaks. Connects intercooler to upper charge pipe.
Added protection for your WMI setup
Stainless Steel exhaust tip featuring a 80MM Inlet & a 4.0" Double Wall, Slant Cut Outlet, Single Clamp On Tip
10X Entries Into Our F80 M3 Sweepstakes
Please note this is a universal tip. You MUST measure your exhaust before ordering to verify fitment for your application.
This product was last offered at the strikethrough price on
05-02-2026
Allows your JB4 to control a WMI pump and solenoid for dynamic progressive flow mapping!
For use in setups where charge pipe injection is being utilized.
A simple way to dress up your engine bay
A modular bracket capable of being used with a single or dual Walbro 450 or 525 fuel pump(s)
Adapt 2" Inlets to your stock turbos!
2X Entries Into Our F80 M3 Sweepstakes
Features OEM-style direct-fit connectors, providing the perfect balance between high-end performance and a cost-effective, factory-like installation.
2X Entries Into Our F80 M3 Sweepstakes
Replace your flimsy, restrictive plastic chargepipe with this high flow charge pipe for a cost efficient upgrade!
Replace your flimsy, restrictive plastic chargepipe with this high flow charge pipe for a cost efficient upgrade! This pipe features an upgraded Tial BOV flange!
Quality retainers from Supertech
Add an Install Kit to Your Motiv ReFlex Control Unit!
Eliminate your failure prone plastic charge pipe and upgrade to this silicone and billet charge pipe from Vargas Turbo Technologies
2X Entries Into Our F80 M3 Sweepstakes
1/4" tee fitting for water/methanol lines
Use these in replacement of any standard short body EV14 style injector.