O-ring that seals the intercooler pipes to the turbo(s)
This product was last offered at the strikethrough price on
05-02-2026
O-ring that seals the intercooler pipes to the turbo(s)
This product was last offered at the strikethrough price on
05-02-2026
Added protection for your WMI setup
Located under the airbox
This product was last offered at the strikethrough price on
05-02-2026
Allows your JB4 to control a WMI pump and solenoid for dynamic progressive flow mapping!
For use in setups where charge pipe injection is being utilized.
High flow WMI solenoid with inline 40 micron filter
Reduce intake manifold heat transfer with this spacer from Evolution of Speed!
Direct replacement charge pipe seal made from Viton to withstand all fuels and oils
Extends the length of your existing harness for the charge pipe T-Map sensor & adapts your OEM map sensor wire to a 3.5 bar map sensor connector
Add an Install Kit to Your Motiv ReFlex Control Unit!
Used to secure the intake boot
This product was last offered at the strikethrough price on
08-26-2026
Front
MSRP stands for Manufacturer's Suggested Retail Price. This is the suggested retail price provided by the manufacturer, supplier or seller.
This product was last offered at the strikethrough price on
09-03-2026
1/4" tee fitting for water/methanol lines
Blasting material used for the carbon build up on the intake
Adjustable (1-15 PSI) to engage at the appropriate amount of boost pressure for your application.
15 PSI
MSRP stands for Manufacturer's Suggested Retail Price. This is the suggested retail price provided by the manufacturer, supplier or seller.
This product was last offered at the strikethrough price on
09-03-2026