E-6000 is semi flexible, 100% methanol resistant, and the only sealant recommended for use with Snow Performance water methanol injection systems.
E-6000 is semi flexible, 100% methanol resistant, and the only sealant recommended for use with Snow Performance water methanol injection systems.
This kit upgrades your WMI plastic lines to stainless steel BMS Elite braided lines.
Snow Performance Hyper-Sonic water-methanol injection nozzle
Snow Performance Hyper-Sonic water-methanol injection nozzle
Better looks, throttle response, and reliability
MSRP stands for Manufacturer's Suggested Retail Price. This is the suggested retail price provided by the manufacturer, supplier or seller.
This product was last offered at the strikethrough price on
09-13-2026
Used to secure the intake boot
MSRP stands for Manufacturer's Suggested Retail Price. This is the suggested retail price provided by the manufacturer, supplier or seller.
This product was last offered at the strikethrough price on
09-13-2026
Added protection for your WMI setup
Allows your JB4 to control a WMI pump and solenoid for dynamic progressive flow mapping!
For use in setups where charge pipe injection is being utilized.
High flow WMI solenoid with inline 40 micron filter
Reduce intake manifold heat transfer with this spacer from Evolution of Speed!
Direct replacement charge pipe seal made from Viton to withstand all fuels and oils
Add an Install Kit to Your Motiv ReFlex Control Unit!
Replace your sensor and avoid poor fuel mileage and hampered performance
1/4" tee fitting for water/methanol lines
1 for each intake runner, 6 in total
10X Entries Into Our F80 M3 Sweepstakes