Water methanol nozzle holders securely connect either nylon line or braided line directly to your water methanol nozzle
Water methanol nozzle holders securely connect either nylon line or braided line directly to your water methanol nozzle
This kit upgrades your WMI plastic lines to stainless steel BMS Elite braided lines.
Extreme Environment 300 PSI UHO Water Methanol Pump
E-6000 is semi flexible, 100% methanol resistant, and the only sealant recommended for use with Snow Performance water methanol injection systems.
Snow Performance Hyper-Sonic water-methanol injection nozzle
Snow Performance Hyper-Sonic water-methanol injection nozzle
Replace your faulty throttle body
10X Entries For Our 25th Anniversary Sweepstakes!
This product was last offered at the strikethrough price on
05-02-2026
Vacuum hose, cable ties, and fitting instructions are supplied and the installation is fully reversible.
Direct replacement charge pipe seal made from Viton to withstand all fuels and oils
MSRP stands for Manufacturer's Suggested Retail Price. This is the suggested retail price provided by the manufacturer, supplier or seller.
This product was last offered at the strikethrough price on
07-18-2026
Add an Install Kit to Your Motiv ReFlex Control Unit!
Added protection for your WMI setup
incl. brackets/check valve/tubing
Located under the airbox
This product was last offered at the strikethrough price on
05-02-2026
Allows your JB4 to control a WMI pump and solenoid for dynamic progressive flow mapping!
For use in setups where charge pipe injection is being utilized.
High flow WMI solenoid with inline 40 micron filter