Added protection for your WMI setup
Added protection for your WMI setup
Located under the airbox
This product was last offered at the strikethrough price on
05-02-2026
Add an Install Kit to Your Motiv ReFlex Control Unit!
Allows your JB4 to control a WMI pump and solenoid for dynamic progressive flow mapping!
For use in setups where charge pipe injection is being utilized.
1/4" tee fitting for water/methanol lines
Direct replacement charge pipe seal made from Viton to withstand all fuels and oils
Replace your sensor and avoid poor fuel mileage and hampered performance
Control heat and dress up your engine bay
Replace your leaking gasket
2X Entries Into Our F80 M3 Sweepstakes
We Price Match - Give Us A Call or Chat!
Vacuum hose, cable ties, and fitting instructions are supplied and the installation is fully reversible.
Keep your CAI from heat soaking with this thermal wrap kit, 36" X 14"
MSRP stands for Manufacturer's Suggested Retail Price. This is the suggested retail price provided by the manufacturer, supplier or seller.
This product was last offered at the strikethrough price on
10-11-2026
High flow WMI solenoid with inline 40 micron filter
Installs easily for an accurate boost reading every time.
For charge pipe!
Adjustable (1-15 PSI) to engage at the appropriate amount of boost pressure for your application.
Control heat and dress up your engine bay