Restore charging system voltage with a new alternator
For vehicles with M Sport package
BMW F32 428i xDrive N20 2.0L Engine Electrical Parts
- Alternator
- Battery
- ECU
- Fuse Panel
- Ground Strap
- Harness
- Ignition
- Pump
- Relays
- Sensors
- Starter
- Throttle Body
- Wire Covering
Price includes a $240.00 Core Charge
MSRP stands for Manufacturer's Suggested Retail Price. This is the suggested retail price provided by the manufacturer, supplier or seller.
This product was last offered at the strikethrough price on
08-09-2026
2.5mm & 25m(75ft) in length
Includes $109.60 core charge
This pre-assembled unit retains your vehicle's OE top-hat, center section, and lower fuel bucket, meaning you get the massive fueling overhead required for aggressive boost increases without sacrificing daily drivability or tank integration.
MSRP stands for Manufacturer's Suggested Retail Price. This is the suggested retail price provided by the manufacturer, supplier or seller.
This product was last offered at the strikethrough price on
08-09-2026
A two-bank onboard battery charger rated at 20-amps (10-amps per bank) for 12-volt batteries, including marine, boat, starter, and deep-cycle batteries.
MSRP stands for Manufacturer's Suggested Retail Price. This is the suggested retail price provided by the manufacturer, supplier or seller.
This product was last offered at the strikethrough price on
08-09-2026
Purchase the wires you need for your electrical bulkhead fitting here. Featuring Black FEP wire pre-cut to 24" 12 Gauge wire with the appropriate terminal pre-crimped and ready to install!
Purchase the wires you need for your electrical bulkhead fitting here. Featuring Orange FEP wire pre-cut to 24" 12 Gauge wire with the appropriate terminal pre-crimped and ready to install!
Purchase the wires you need for your electrical bulkhead fitting here. Featuring Black FEP wire pre-cut to 24" 18 Gauge wire with the appropriate terminal pre-crimped and ready to install!
Purchase the wires you need for your electrical bulkhead fitting here. Featuring White FEP wire pre-cut to 24" 12 Gauge wire with the appropriate terminal pre-crimped and ready to install!
Purchase the wires you need for your electrical bulkhead fitting here. Featuring Blue FEP wire pre-cut to 24" 12 Gauge wire with the appropriate terminal pre-crimped and ready to install!
Purchase the wires you need for your electrical bulkhead fitting here. Featuring FEP wire pre-cut to 24" 12 Gauge wire with the appropriate terminal pre-crimped and ready to install!
Replace your faulty sensor to restore engine performance and fuel economy
Sits on top of the battery
10X Entries For Our 25th Anniversary Sweepstakes!
This product was last offered at the strikethrough price on
05-02-2026