All the necessities to move your tank to the trunk of any vehicle.
All the necessities to move your tank to the trunk of any vehicle.
Direct replacement from BMW!
Commonly used to seal the high pressure fuel pump.
MSRP stands for Manufacturer's Suggested Retail Price. This is the suggested retail price provided by the manufacturer, supplier or seller.
This product was last offered at the strikethrough price on
04-14-2026
Includes fuel pump, level sensor, fuel filter, and o-ring
2X Entries Into Our F80 M3 Sweepstakes
We Price Match - Give Us A Call or Chat!
Seal that goes from the end of the injector to the motor
The ultimate supplementary fueling kit for the N54 and N55 engines!
Adjustable High Flow Fuel Pressure Regulator with 1 to 1 boost reference
Externally mounted fuel relay
We Price Match - Give Us A Call or Chat!
Trunk mounted control unit
MSRP stands for Manufacturer's Suggested Retail Price. This is the suggested retail price provided by the manufacturer, supplier or seller.
This product was last offered at the strikethrough price on
09-22-2026
Provides up to 85% more fuel flow than stock injectors!
Genuine Bosch Motorsports EV14 fuel injectors featuring USCAR (EV6) connector matched and packaged in pack of 6 units - Minimum flow of 1300cc @ 3bar (43.5 PSI industry standard)
NOT A DIRECT REPLACEMENT FOR FACTORY INJECTORS - For use with aftermarket port injection kits only
W/Brackets, Solenoid, Hose & All Necessary Fittings
Trunk mounted control unit
We Price Match - Give Us A Call or Chat!
Rein OE quality GDI fuel feed pipe
2X Entries Into Our F80 M3 Sweepstakes
We Price Match - Give Us A Call or Chat!
This product was last offered at the strikethrough price on
08-31-2026
Includes fuel pump, level sensor, fuel filter, and o-ring
MSRP stands for Manufacturer's Suggested Retail Price. This is the suggested retail price provided by the manufacturer, supplier or seller.
This product was last offered at the strikethrough price on
09-22-2026
Genuine Bosch Motorsports EV14 fuel injectors featuring USCAR (EV6) connector matched and packaged in pack of 6 units - Minimum flow of 950cc @ 3bar (43.5 PSI industry standard)
NOT A DIRECT REPLACEMENT FOR FACTORY INJECTORS - For use with aftermarket port injection kits only
This product was last offered at the strikethrough price on
08-25-2026