Replace those Worn Out Rod Bearings!
+0.75mm
This product was last offered at the strikethrough price on
08-13-2026
Replace those Worn Out Rod Bearings!
+0.75mm
This product was last offered at the strikethrough price on
08-13-2026
Snow Performance Hyper-Sonic water-methanol injection nozzle
Runs from the compressor outlet to the intercooler
Secures items under the hood and resists rust
15 PSI
Added protection for your WMI setup
Main Injector Harness For Inline-6 Motiv ReFlex Lite Applications
Stainless Steel exhaust tip featuring a 80MM Inlet & a 4.0" Double Wall, Slant Cut Outlet, Single Clamp On Tip
10X Entries Into Our F80 M3 Sweepstakes
Please note this is a universal tip. You MUST measure your exhaust before ordering to verify fitment for your application.
This product was last offered at the strikethrough price on
05-02-2026
Allows your JB4 to control a WMI pump and solenoid for dynamic progressive flow mapping!
For use in setups where charge pipe injection is being utilized.
High flow WMI solenoid with inline 40 micron filter
Add some design flare to your engine bay!
1/4" tee fitting for water/methanol lines
Left - Mirror Slash Cut Exhaust Tip - 2.75 Inlet - 3.5 OD
10X Entries Into Our F80 M3 Sweepstakes
Not vehicle specific. You MUST measure prior to purchasing!
This product was last offered at the strikethrough price on
06-13-2026
Adjustable (1-15 PSI) to engage at the appropriate amount of boost pressure for your application.
Use these in replacement of any standard short body EV14 style injector.
Replacement WMI Water Injection Hose