For use in front & rear open differentials as well as some manual transmissions
For use in front & rear open differentials as well as some manual transmissions
Universal exhaust tips with a swivel adjustability to fine tune your exhaust. 2.5" Inlet & a 3.5" Double Wall, Angle Cut Outlet
10X Entries Into Our F80 M3 Sweepstakes
Can be used on any 2.5" exhaust piping. Measure before ordering.
This product was last offered at the strikethrough price on
06-13-2026
Stainless Steel exhaust tip featuring a 2.5" Inlet & a 4.0" Double Wall, Angle Cut Outlet
10X Entries Into Our F80 M3 Sweepstakes
Not vehicle specific. You MUST measure prior to purchasing!
This product was last offered at the strikethrough price on
06-13-2026
This Professional quality crimper/stripper has the hard to find open barrel crimp option used on many German cars.
10X Entries Into Our F80 M3 Sweepstakes
This product was last offered at the strikethrough price on
05-02-2026
Used primarily on trunk panels of BMW models
Found in the engine block.
MSRP stands for Manufacturer's Suggested Retail Price. This is the suggested retail price provided by the manufacturer, supplier or seller.
This product was last offered at the strikethrough price on
06-05-2026
One wrench fits many oil, Differential and Transfer Case Plugs
10X Entries Into Our F80 M3 Sweepstakes
This product was last offered at the strikethrough price on
05-02-2026
Thin-wall design with MAGNET for tight clearance and easy extraction
Filter dimensions (4"F x 6"B x 4"T x 5"H)
MSRP stands for Manufacturer's Suggested Retail Price. This is the suggested retail price provided by the manufacturer, supplier or seller.
This product was last offered at the strikethrough price on
05-27-2026
Featuring low profile heads with 180 degress of articulation - Includes 1/4" and 3/8" square drive adapters
This product was last offered at the strikethrough price on
09-16-2026
Measure your camber quickly and accurately
10X Entries Into Our F80 M3 Sweepstakes
This product was last offered at the strikethrough price on
05-02-2026
ABS plastic universal fender flares that add 4cm of width per side
Includes required installation hardware and length of gasket
Fits all standard gallon bottles
High quality heat resistant tubing that lasts! 3mm
Apply to the rear of pads, guide pins, and caliper slides to reduce unwanted brake noise
Air Lift Performance 3S Manifold, ALP3 Controller, 3/8" PTC Fittings, no tank, no compressor