Added protection for your WMI setup
Added protection for your WMI setup
Everything you need to replace or upgrade your intake manifold!
Add an Install Kit to Your Motiv ReFlex Control Unit!
Allows your JB4 to control a WMI pump and solenoid for dynamic progressive flow mapping!
For use in setups where charge pipe injection is being utilized.
1/4" tee fitting for water/methanol lines
Completely seals the factory head ports to prevent oil intrusion and unwanted vacuum leaks
2X Entries Into Our F80 M3 Sweepstakes
Smooths the airflow from the intake to the factory turbo inlet by removing the upper factory sound resonator and the lower accordion section of the air inlet pipe
Only works with the factory BMW B58 intake
Control heat and dress up your engine bay
Seals the intake manifold to the cylinder head.
This product was last offered at the strikethrough price on
08-26-2026
Improved filtration and increased flow in a washable, reusable element.
MSRP stands for Manufacturer's Suggested Retail Price. This is the suggested retail price provided by the manufacturer, supplier or seller.
This product was last offered at the strikethrough price on
10-08-2026
Keep your CAI from heat soaking with this thermal wrap kit, 36" X 14"
MSRP stands for Manufacturer's Suggested Retail Price. This is the suggested retail price provided by the manufacturer, supplier or seller.
This product was last offered at the strikethrough price on
10-08-2026
High flow WMI solenoid with inline 40 micron filter
Adjustable (1-15 PSI) to engage at the appropriate amount of boost pressure for your application.
Control heat and dress up your engine bay
Control heat and dress up your engine bay
MSRP stands for Manufacturer's Suggested Retail Price. This is the suggested retail price provided by the manufacturer, supplier or seller.
This product was last offered at the strikethrough price on
10-08-2026
ID=80mm/3.15", 7" long & 7" outer diameter