Brings true 2D mapped water-methanol injection delivery to your EFI (Electronic Fuel Injected) and forced induction vehicle
Brings true 2D mapped water-methanol injection delivery to your EFI (Electronic Fuel Injected) and forced induction vehicle
The ultimate supplementary fueling kit for the B58 engine!
Filter for Inline Fuel Filter AN8 Single In/Out unit
This product was last offered at the strikethrough price on
01-22-2026
Genuine replacement fuel pump/fuel supply module assembly
MSRP stands for Manufacturer's Suggested Retail Price. This is the suggested retail price provided by the manufacturer, supplier or seller.
This product was last offered at the strikethrough price on
07-19-2026
Recommended to be replaced when replacing fuel pump
This product was last offered at the strikethrough price on
02-23-2026
Flows up to 26% more than S58 inejctors and 60% more than B58 injectors
For vehicles with the Gen2 B58 (B58C / B58D) engine only - Not compatible with the earlier Gen1 B58A or Gen3 B58N engines
Seal that goes from the end of the injector to the motor
A stand alone low-pressure fuel system dedicated to your port fueling - flows 800LPH at 3 Bar!
Direct replacement from BMW!
A stand alone low-pressure fuel system dedicated to your port fueling - flows 640LPH at 3 Bar!
Genuine Bosch Motorsports EV14 fuel injectors featuring USCAR (EV6) connector matched and packaged in pack of 6 units - Minimum flow of 1300cc @ 3bar (43.5 PSI industry standard)
2X Entries For Our 25th Anniversary Sweepstakes!
NOT A DIRECT REPLACEMENT FOR FACTORY INJECTORS - For use with aftermarket port injection kits only
Adjustable High Flow Fuel Pressure Regulator with 1 to 1 boost reference
Remove you injectors without causing damage
This product was last offered at the strikethrough price on
01-26-2026
W/Brackets, Solenoid, Hose & All Necessary Fittings
Get a full flow from your E85 flex fuel sensors to your fuel rails.
Genuine Bosch Motorsports EV14 fuel injectors featuring USCAR (EV6) connector matched and packaged in pack of 6 units - Minimum flow of 950cc @ 3bar (43.5 PSI industry standard)
2X Entries For Our 25th Anniversary Sweepstakes!
NOT A DIRECT REPLACEMENT FOR FACTORY INJECTORS - For use with aftermarket port injection kits only
This product was last offered at the strikethrough price on
06-25-2026