All the necessities to move your tank to the trunk of any vehicle.
All the necessities to move your tank to the trunk of any vehicle.
Recommended to be replaced when replacing fuel pump
This product was last offered at the strikethrough price on
06-15-2026
Flows up to 26% more than S58 inejctors and 60% more than B58 injectors
For vehicles with the Gen2 B58 (B58C / B58D) engine only - Not compatible with the earlier Gen1 B58A or Gen3 B58N engines
Complete with sealing gasket and tether.
10X Entries Into Our F80 M3 Sweepstakes
This product was last offered at the strikethrough price on
08-19-2026
Commonly used to seal the high pressure fuel pump.
MSRP stands for Manufacturer's Suggested Retail Price. This is the suggested retail price provided by the manufacturer, supplier or seller.
This product was last offered at the strikethrough price on
04-14-2026
Direct replacement from BMW!
Adjustable High Flow Fuel Pressure Regulator with 1 to 1 boost reference
Seal that goes from the end of the injector to the motor
Genuine Bosch Motorsports EV14 fuel injectors featuring USCAR (EV6) connector matched and packaged in pack of 6 units - Minimum flow of 1300cc @ 3bar (43.5 PSI industry standard)
NOT A DIRECT REPLACEMENT FOR FACTORY INJECTORS - For use with aftermarket port injection kits only
Remove you injectors without causing damage
Located On the Fuel Line
MSRP stands for Manufacturer's Suggested Retail Price. This is the suggested retail price provided by the manufacturer, supplier or seller.
This product was last offered at the strikethrough price on
07-06-2026
W/Brackets, Solenoid, Hose & All Necessary Fittings
Get a full flow from your E85 flex fuel sensors to your fuel rails.
Brings true 2D mapped water-methanol injection delivery to your EFI (Electronic Fuel Injected) and forced induction vehicle
Rein OE quality GDI fuel feed pipe
2X Entries Into Our F80 M3 Sweepstakes
We Price Match - Give Us A Call or Chat!
This product was last offered at the strikethrough price on
08-31-2026
Genuine Bosch Motorsports EV14 fuel injectors featuring USCAR (EV6) connector matched and packaged in pack of 6 units - Minimum flow of 950cc @ 3bar (43.5 PSI industry standard)
NOT A DIRECT REPLACEMENT FOR FACTORY INJECTORS - For use with aftermarket port injection kits only
This product was last offered at the strikethrough price on
08-25-2026