Protects The Positive (+) Battery Terminal
Protects The Positive (+) Battery Terminal
Purchase the wires you need for your electrical bulkhead fitting here. Featuring Red FEP wire pre-cut to 24" 12 Gauge wire with the appropriate terminal pre-crimped and ready to install!
M10x90
Two (2) Required - Secures Starter To Bell Housing
Copper crimpable terminal ends for custom battery and kill switch installations
Extra length is needed sometimes
Every thing you need to keep your battery terminals clean.
This product was last offered at the strikethrough price on
05-27-2026
Plugs directly into your 12 volt receptacle to prevent lost presets and settings while the battery is disconnected.
M6x16
One (1) Required - Secures Crankshaft Position Sensor To The Crankcase
Sends the signal for the coolant temperature gauge
2X Entries Into Our F80 M3 Sweepstakes
Sends the signal for the coolant temperature gauge
5X Entries Into Our F80 M3 Sweepstakes
We Price Match - Give Us A Call or Chat!
This product was last offered at the strikethrough price on
06-23-2026
Stop that annoying leak with a new o-ring
Seals the gap between the throttle body and the intake manifold
For securing sensors in their housing
Purchase the wires you need for your electrical bulkhead fitting here. Featuring FEP wire pre-cut to 24" 18 Gauge wire with the appropriate terminal pre-crimped and ready to install!
Prevents fluid leaks
Stop that annoying leak with a new o-ring
This product was last offered at the strikethrough price on
05-07-2026