MAHLE Original Mercedes-Benz Intake Manifold Set
2006 Mercedes Benz CLK350 Base Convertible 209.456 V6 3.5L Engine Parts & Accessories
- Cooling
- Covers
- Drive Belts
- Electrical
- Emissions
- Fastener Kit
- Filter
- Fuel
- Gaskets & Seals
- Ignition
- Intake
- Mechanical
- Mount
- Oil Service
- Performance
- Pulleys
- Timing
- Tools
- Turbocharger
- Vacuum System
Set of two engine air filters for your vehicle
2X Entries For Our 25th Anniversary Sweepstakes!
We Price Match - Give Us A Call or Chat!
This product was last offered at the strikethrough price on
06-19-2026
Fuel injector seal
One (1) Required Per Injector - Lower Seal
This product was last offered at the strikethrough price on
05-02-2026
Seals the gap between the crankshaft and engine block
2X Entries For Our 25th Anniversary Sweepstakes!
We Price Match - Give Us A Call or Chat!
Seal W/PTFE Components, PTFE Seal Installation Tool Required, Let Settle For Four (4) Hours After Installation Before Use
This product was last offered at the strikethrough price on
08-14-2026
Hose between combination valve and air pump
We Price Match - Give Us A Call or Chat!
Seals the gap between the thermostat housing and the engine
This product was last offered at the strikethrough price on
06-23-2026
Monitor the condition of your engine's lubricating system at each service and remove harmful metallic contaminants from imposing premature wear. M14x1.5mm thread
2X Entries For Our 25th Anniversary Sweepstakes!
Oil cooler/filter housing to timing case
2X Entries For Our 25th Anniversary Sweepstakes!
We Price Match - Give Us A Call or Chat!
This product was last offered at the strikethrough price on
05-07-2026
Partial-Load Oil Separation
We Price Match - Give Us A Call or Chat!
Should be replaced periodically to maintain proper cooling system operation
All the plugs needed to get the job done right
Should be replaced periodically to maintain proper cooling system operation
2X Entries For Our 25th Anniversary Sweepstakes!
We Price Match - Give Us A Call or Chat!
This product was last offered at the strikethrough price on
03-01-2026
Seal for fuel pump and sending unit in the fuel tank
2X Entries For Our 25th Anniversary Sweepstakes!
We Price Match - Give Us A Call or Chat!
Seals the gap between the crankshaft and engine block (45 X 67 X 8 mm)
Seal W/PTFE Components, PTFE Seal Installation Tool Required, Let Settle For Four (4) Hours After Installation Before Use
This product was last offered at the strikethrough price on
08-13-2026
Eliminate hassles with new hardware
Two (2) Required - Fuel Tank Strap To Chassis - Front Position
Timing case to cylinder crankcase
Timing Cover Lower Seal
This product was last offered at the strikethrough price on
05-07-2026