This kit upgrades your WMI plastic lines to stainless steel BMS Elite braided lines.
This kit upgrades your WMI plastic lines to stainless steel BMS Elite braided lines.
Restore the factory intake performance
10X Entries Into Our F80 M3 Sweepstakes
This product was last offered at the strikethrough price on
05-02-2026
Snow Performance Hyper-Sonic water-methanol injection nozzle
Blasting material used for the carbon build up on the intake
This product was last offered at the strikethrough price on
05-07-2026
Connects to the intake boot tube
MSRP stands for Manufacturer's Suggested Retail Price. This is the suggested retail price provided by the manufacturer, supplier or seller.
This product was last offered at the strikethrough price on
09-03-2026
Snap in cap with seal
MSRP stands for Manufacturer's Suggested Retail Price. This is the suggested retail price provided by the manufacturer, supplier or seller.
This product was last offered at the strikethrough price on
09-03-2026
Used to clean the filter
Added protection for your WMI setup
Reads the temperature and rates for the fuel/ air
This product was last offered at the strikethrough price on
05-07-2026
Allows your JB4 to control a WMI pump and solenoid for dynamic progressive flow mapping!
For use in setups where charge pipe injection is being utilized.
High flow WMI solenoid with inline 40 micron filter
Used most commonly on the exhaust studs, M8
Upgrade your filter to aFe
This product was last offered at the strikethrough price on
09-01-2026
1/4" tee fitting for water/methanol lines
Makes walnut blasting easier, newer design
10X Entries Into Our F80 M3 Sweepstakes
double thread bolt used near the turbo