For fitting Milltek high flow catalytic to stock mid-pipe
This product was last offered at the strikethrough price on
09-18-2026
For fitting Milltek high flow catalytic to stock mid-pipe
This product was last offered at the strikethrough price on
09-18-2026
Service kit for FMDv004
This product was last offered at the strikethrough price on
09-18-2026
Added protection for your WMI setup
Used to add a back pipe system to the stock/performance USA Downpipe
Stainless Steel exhaust tip featuring a 80MM Inlet & a 4.0" Double Wall, Slant Cut Outlet, Single Clamp On Tip
10X Entries Into Our F80 M3 Sweepstakes
Please note this is a universal tip. You MUST measure your exhaust before ordering to verify fitment for your application.
This product was last offered at the strikethrough price on
05-02-2026
Allows your JB4 to control a WMI pump and solenoid for dynamic progressive flow mapping!
For use in setups where charge pipe injection is being utilized.
1/4" tee fitting for water/methanol lines
Replacement oiled filter
Stylish protective waterproof case for your JB1 or JB4
Left - Mirror Slash Cut Exhaust Tip - 2.75 Inlet - 3.5 OD
10X Entries Into Our F80 M3 Sweepstakes
Not vehicle specific. You MUST measure prior to purchasing!
This product was last offered at the strikethrough price on
06-13-2026
15 PSI
Use these in replacement of any standard short body EV14 style injector.
Part of the front section of the Non resonated cat back. Not a full system.
This product was last offered at the strikethrough price on
09-18-2026
For use with ITG foam filters
This product was last offered at the strikethrough price on
05-27-2026
High flow WMI solenoid with inline 40 micron filter
Adjustable (1-15 PSI) to engage at the appropriate amount of boost pressure for your application.