The Race Port is famous for being an amazingly small and light BOV for turbocharged competition level engines
*General use blow off valve for custom big turbo applications - Not a direct fit valve*
The Race Port is famous for being an amazingly small and light BOV for turbocharged competition level engines
*General use blow off valve for custom big turbo applications - Not a direct fit valve*
M14x1.5x75mm with conical nuts
2X Entries For Our 25th Anniversary Sweepstakes!
Eliminate deflection caused by the stock rubber bushings for improved cornering ability, accel and decel response
10X Entries For Our 25th Anniversary Sweepstakes!
This product was last offered at the strikethrough price on
06-13-2026
Keep your engine planted and transfer as much power to the ground as possible
Necessary bolts and nuts to be replaced with rear toe arm installation
This product was last offered at the strikethrough price on
07-05-2026
Includes everything you need to install spacers on two wheels
10X Entries For Our 25th Anniversary Sweepstakes!
Please measure your hub protrusion to ensure it will still make contact with the center of the wheel. See
This product was last offered at the strikethrough price on
06-13-2026
Includes everything you need to install spacers on two wheels
10X Entries For Our 25th Anniversary Sweepstakes!
Recommended for front fitment only. May not clear rear wheel bearing dust cap. See notes for more info.
This product was last offered at the strikethrough price on
06-13-2026
Lower and optimize your Beetle's suspension
Dress up your ignition coil hardware with this kit
10X Entries For Our 25th Anniversary Sweepstakes!
Must have pre-existing ignition coil studs - Please inspect before ordering - See ES2806864 for studs
This product was last offered at the strikethrough price on
06-13-2026
Helps maintain proper suspension geometry for improved handling and less rear steer feeling
Comes with everything you need to install spacers on two wheels
10X Entries For Our 25th Anniversary Sweepstakes!
Please measure your hub protrusion to ensure it will still make contact with the center of the wheel. See
This product was last offered at the strikethrough price on
06-13-2026
Average lowering front & rear: 0.98"
These are high-quality, stainless lines that are DOT approved.
These are intended to be installed on cars equipped with 253mm rear brakes only
Complete control arm bushing kit with anti-lift geometry for added traction
Multiple shim sizes for Wavetrac DSG 10-309-185WK through 10-309-188W
Fine tune your stance and improve handling
10X Entries For Our 25th Anniversary Sweepstakes!
We Price Match - Give Us A Call or Chat!
Fits hub height contour up to 12mm. Inside wheel bevel = 4mm x 45 degrees
MSRP stands for Manufacturer's Suggested Retail Price. This is the suggested retail price provided by the manufacturer, supplier or seller.
This product was last offered at the strikethrough price on
07-01-2026