Brings true 2D mapped water-methanol injection delivery to your EFI (Electronic Fuel Injected) and forced induction vehicle
Brings true 2D mapped water-methanol injection delivery to your EFI (Electronic Fuel Injected) and forced induction vehicle
Brings true 2D mapped water-methanol injection delivery to your DI (direct fuel injected) and forced induction vehicle
Version 1.
Designed for high performance naturally aspirated and forced induction EFI vehicles - It can be installed externally or in-tank using optional hardware that is sold separately
This is a general-use high flow fuel pump, not a direct plug-and-play swap in most application
MSRP stands for Manufacturer's Suggested Retail Price. This is the suggested retail price provided by the manufacturer, supplier or seller.
This product was last offered at the strikethrough price on
11-01-2026
Get access to even more vehicle data using PROLINK+ to wire in up to 2x analog signals and 1x CAN bus signal. Compatible with MPVI2+ and MPVI3 interfaces.
For use with HP Tuners MPVI2+ and MPVI3 interfaces only.
This product was last offered at the strikethrough price on
05-12-2026
High-Flow Low-Current WMI Solenoid - 200PSI 1/8in-27NPT In/Out
MSRP stands for Manufacturer's Suggested Retail Price. This is the suggested retail price provided by the manufacturer, supplier or seller.
This product was last offered at the strikethrough price on
11-01-2026
Average gain of 90 horsepower and 150 lb-ft of torque, power results vary depending on your modifications
Requires VNT-17 based hybrid turbo upgrade, 3.0 bar MAP sensor, VCDS logging, upgraded fuel injectors, and upgraded clutch if not equipped with factory L
Brings true 2D mapped water-methanol injection delivery to your EFI (Electronic Fuel Injected) and forced induction vehicle
A more solid bridge between your chassis and transmission for a better driving experience.
Unlock 50-70 HP on your boosted vehicle while decreasing your air temps by up to 100 degrees! Stainless Steel Braided Line, 4AN Fittings, no tank included!
These mounts are designed with performance in mind, manufactured from billet aluminum and high-durometer rubber, making them virtually indestructible.
2X Entries Into Our F80 M3 Sweepstakes
For vehicles with manual transmission only
Average gain of 60 horsepower and 115 lb-ft of torque
Requires VNT-17 turbo upgrade, 3.0 bar MAP sensor, upgraded fuel injectors, and upgraded clutch if not equipped with factory Luk clutch. For vehicles fro
Average gain of 40 horsepower and 68 lb-ft of torque
Designed to handle continuous temperatures up to 1,800°F
Replacement JB4 OBDII cable suitable for use in all applications where the JB4 attaches to the OBDII port under the dash.
Sold in a black powdercoated finish.
2X Entries Into Our F80 M3 Sweepstakes