Set of 6
5X Entries For Our 25th Anniversary Sweepstakes!
Set of 6
5X Entries For Our 25th Anniversary Sweepstakes!
Includes upper and lower bearing shells for a complete rod bearing replacement.
Includes springs, retainers, and valve seats
IE Street Intake Camshaft for 300+ Horsepower Builds!
5X Entries For Our 25th Anniversary Sweepstakes!
Set of 4, rifle drilled
5X Entries For Our 25th Anniversary Sweepstakes!
Drop in for engine code AWM only
Stock sized valve head diameter, factory triple groove keeper setup - Includes Supertech valves and IE valve seals
10X Entries For Our 25th Anniversary Sweepstakes!
*Existing factory triple-groove valve keepers are to be reused*
Takes 1.8L 06A engine to 2.0L (2008cc), by increasing the stroke and bore of the engine
Requires block machine work (+2mm overbore) - To be used in conjunction with IE 2.0L Stroker Crank (IESKVA6) and 144x20 connecting rods
IE Race Exhaust Camshaft for 500+ Horsepower Builds!
5X Entries For Our 25th Anniversary Sweepstakes!
IE Race Intake Camshaft for 500+ Horsepower Builds!
5X Entries For Our 25th Anniversary Sweepstakes!
High quality precision wound/exact tolerance performance valves and titanium retainers
5X Entries For Our 25th Anniversary Sweepstakes!
Complete set of Ferrea high performance valve springs, and titanium retainers
5X Entries For Our 25th Anniversary Sweepstakes!
Includes rings, wire locks, and wrist pins - 81.5mm bore (0.5mm overbore), 8.5:1 CR, 86.4mm stroke (stock)
*For use with 20mm wrist pin connecting rods*
Includes rings, wire locks, and wrist pins - 81mm bore (stock), 8.5:1 CR, 86.4mm stroke (stock)
*For use with 20mm wrist pin connecting rods*
Includes rings, wire locks, and wrist pins - 82mm bore (1mm overbore), 9.25:1 CR, 86.4mm stroke (stock)
*For use with 20mm wrist pin connecting rods*
+1mm oversized valve head diameter, single groove keeper setup for high RPM use - Includes Supertech valves, single groove keepers and IE valve seals
10X Entries For Our 25th Anniversary Sweepstakes!
+1mm oversized valves & singe groove keeper setup - Requires machine work to cylinder head
Includes rings, wire locks, and wrist pins - 82mm bore, 9:8 CR, 86.4mm stroke (stock)
*For use with 20mm wrist pin connecting rods*