Replaced during a clutch service
We Price Match - Give Us A Call or Chat!
Replaced during a clutch service
We Price Match - Give Us A Call or Chat!
Replace your sloppy rubber manual trans shift bracket bushings with upgraded aluminum bushings from 034 Motorsport!
2X Entries Into Our F80 M3 Sweepstakes
For vehicles with manual transmission only
This product was last offered at the strikethrough price on
08-17-2026
Street and track torture tested
For vehicles with manual transmission only
Pentosin DOT 5.1 Class 7 Low Viscosity Brake Fluid. Ultra High-Performance Brake Fluid for hydraulic brake systems and clutch actuation in passenger cars, trucks, and motorcycles.
This product was last offered at the strikethrough price on
09-01-2026
Seals the connection between the axle flange and transmission
Used in various locations. M8x83.2mm
For vehicles with manual transmission only
For vehicles with manual transmission only
Secures the flywheel to crankshaft. M10X1X22.3
prevents dust and dirt from entering your transmission
MSRP stands for Manufacturer's Suggested Retail Price. This is the suggested retail price provided by the manufacturer, supplier or seller.
This product was last offered at the strikethrough price on
05-09-2026
Shift with confidence with a solid and direct feel
Hex collared bolt used to secure the slave cylinder to the transmission. M7x25
Used to secure the release bearing/slave cylinder - Total of 3 required.
MSRP stands for Manufacturer's Suggested Retail Price. This is the suggested retail price provided by the manufacturer, supplier or seller.
This product was last offered at the strikethrough price on
09-05-2026
Max-Gear is recommended for use in front or rear open differentials, manual transmissions, and lower gear units of marine engines that specify use of an API GL-5 or GL-4 fluid
For heavily-loaded racing differentials and transmissions, problem gearboxes
For Custom Applications Only.
Offers higher wet boiling point than DOT 4 fluid
2X Entries Into Our F80 M3 Sweepstakes
For shorter, crisp shifts
Replacement slave cylinder with integrated throwout bearing
For use with OEM clutches or aftermarket clutches that utilize factory geometry only. Not compatible with ECS Clutch Kits.
This product was last offered at the strikethrough price on
05-07-2026
DOT4 compliant. Boiling point - Dry 307°C (585°F) / Wet 185°C (365°F)
2X Entries Into Our F80 M3 Sweepstakes
MSRP stands for Manufacturer's Suggested Retail Price. This is the suggested retail price provided by the manufacturer, supplier or seller.
This product was last offered at the strikethrough price on
09-05-2026