82.5mm bore (standard), 9.1:1 compression ratio, 92.8mm stroke - Includes rings, wrist-pins, & circlips
For vehicles with FSI engines only
82.5mm bore (standard), 9.1:1 compression ratio, 92.8mm stroke - Includes rings, wrist-pins, & circlips
For vehicles with FSI engines only
Replace your worn out valve cover and faulty stock PCV with this raw finish billet valve cover.
High quality performance valve springs and titanium retainers
Increase flow for more power!
Includes upper and lower bearing shells for a complete rod bearing replacement.
This product was last offered at the strikethrough price on
10-07-2026
Set of 4, rifle drilled
For vehicles with ATW or AWM engine code only
Stock sized valve head diameter, factory triple groove keeper setup - Includes Supertech valves and IE valve seals
10X Entries Into Our F80 M3 Sweepstakes
*Existing factory triple-groove valve keepers are to be reused*
Lighter, stiffer, and supports higher revving!
Call In Or Chat For Best Price!
MSRP stands for Manufacturer's Suggested Retail Price. This is the suggested retail price provided by the manufacturer, supplier or seller.
This product was last offered at the strikethrough price on
11-03-2026
Takes 1.8L 06A engine to 2.0L (2008cc), by increasing the stroke and bore of the engine
Requires block machine work (+2mm overbore) - To be used in conjunction with IE 2.0L Stroker Crank (IESKVA6) and 144x20 connecting rods
piston set with the strength to withstand high power numbers
Requires 2mm overbore
Billet main caps for your high horsepower extreme build
Set of 6
Complete set of Ferrea high performance valve springs, and titanium retainers
Includes rings, wrist pins, and pin locks - 83mm bore +.5mm overbore, 9.04:1 CR, 92.8mm stroke (stock) 20mm wrist pin
For vehicles with FSI engines only
Includes rings, wire locks, and wrist pins - 81mm bore (stock), 8.5:1 CR, 86.4mm stroke (stock)
*For use with 20mm wrist pin connecting rods*
Includes rings, wire locks, and wrist pins - 81.5mm bore (0.5mm overbore), 8.5:1 CR, 86.4mm stroke (stock)
*For use with 20mm wrist pin connecting rods*