Our Red Kevlar accessory Belts are both an aesthetic improvement and a performance alternative to a traditional belt.
10X Entries Into Our F80 M3 Sweepstakes
Our Red Kevlar accessory Belts are both an aesthetic improvement and a performance alternative to a traditional belt.
10X Entries Into Our F80 M3 Sweepstakes
Stock sized valve head diameter, factory triple groove keeper setup - Includes Supertech valves and IE valve seals
10X Entries Into Our F80 M3 Sweepstakes
*Existing factory triple-groove valve keepers are to be reused*
Designed to hold up to 425 ft/lbs of torque to the wheels with a sprung ceramic disc and steel flyweel
Lighter, stiffer, and supports higher revving!
Call In Or Chat For Best Price!
MSRP stands for Manufacturer's Suggested Retail Price. This is the suggested retail price provided by the manufacturer, supplier or seller.
This product was last offered at the strikethrough price on
09-28-2026
Designed for dedicated track cars. Conservatively rated at 425ft/lbs.
Endurance clutch holds up to 450 FT LBS TQ
For vehicles with FSI engine only
Endurance clutch holds up to 450 FT LBS TQ
Get up to +54 hp and +60 lb-ft through a safe and easy to use app-controlled tuning module from RaceChip
For vehicles with TSI engines only.
Includes everything you need to install spacers on two wheels
10X Entries Into Our F80 M3 Sweepstakes
Please measure your hub protrusion to ensure it will still make contact with the center of the wheel. See
This product was last offered at the strikethrough price on
06-13-2026
Stainless steel construction for factory downpipe
Direct-bolt on solution for Macan caliper kit
This product was last offered at the strikethrough price on
09-22-2026
Set your vehicle low and tight for optimal performance.
Average lowering of 1.2"-2.0"F, 1.2"-2.0"R
Height adjustable with average lowering of 1.2"-2.8"F, 1.6"-2.8"R.
Fits both sedan and wagon models
Height adjustable with average lowering of 1.6"-2.8"F, 1.2"-2.8"R.
Fits both sedan and wagon
Replacement 2.75" inlet air filter for CTS intakes with 2.75" piping
This product was last offered at the strikethrough price on
09-29-2026
Takes 1.8L 06A engine to 2.0L (2008cc), by increasing the stroke and bore of the engine
Requires block machine work (+2mm overbore) - To be used in conjunction with IE 2.0L Stroker Crank (IESKVA6) and 144x20 connecting rods