Forged Alloy pistons with 22mm wrist pin - Varying Comp Ratio: (2.0T TSI EA888 Gen 1 & 2 (2008-2014): 9.5:1 CR), (2.0T TSI EA888 Gen 3 (2015+): 9.3:1 CR)
Forged Alloy pistons with 22mm wrist pin - Varying Comp Ratio: (2.0T TSI EA888 Gen 1 & 2 (2008-2014): 9.5:1 CR), (2.0T TSI EA888 Gen 3 (2015+): 9.3:1 CR)
Set of 4 connecting rods, to be paired with 22mm wrist pin aftermarket pistons (JE, Wiseco, Mahle ETC)
To be used with aftermarket pistons with 22mm wrist pin
High quality performance valve springs and titanium retainers
Forged Alloy pistons with 22mm wrist pin with +.5mm overbore
Must bore and hone the block to exact specification to ensure the best results
144x20mm forged H-beam rods from Integrated Engineering.
*To be used with aftermarket pistons with 20mm wrist pins*
The highest quality race bearings available.
Not for use with stock rods
Aftermarket performance intake and exhaust valve springs and retainers for your high revving FSI.
MSRP stands for Manufacturer's Suggested Retail Price. This is the suggested retail price provided by the manufacturer, supplier or seller.
This product was last offered at the strikethrough price on
10-07-2026
A high-performance bottom-end rebuild kit featuring Tuscan I-beam connecting rods and 83mm overbore forged pistons.
To be used with aftermarket pistons with 22mm wrist pin
Complete set includes 8 stainless intake valves, 8 inconel exhaust valves, and 32 single groove keepers
Includes upper and lower bearing shells for a complete main bearing replacement. .001 Oil Clearance.
Forged alloy pistons - 82.5mm Bore (stock), 20mm wrist pins, 9.0:1 compression ratio
Includes rings, wire locks, and wrist pins - 81.5mm bore, 9:1 CR, 86.4mm stroke (stock)
*For use with 20mm wrist pin connecting rods*
High quality performance valve spings and titanium retainers
Stock sized valve head diameter, factory triple groove keeper setup - Includes Supertech valves and IE valve seals
10X Entries Into Our F80 M3 Sweepstakes
*Existing factory triple-groove valve keepers are to be reused*
Designed to withstand up to 1100hp!
144x20mm forged H-beam rods from Integrated Engineering.
*To be used with aftermarket pistons with 20mm wrist pins*